Seip Skr433 Remote Control Garage Door 433 Skrj433 Skr433-1 Skr433-3 Handheld Transmitter Gate Opener Seip Command Rolling Code

• Customization: Available
• Frequency: 433.92MHz
• Certification: CE
• Model NO.: SMG-015SEIP
• Code: Rolling Code
• Distance: 10-50m Open Space
• Battery: Include
• Transport Package: Box or Bubble Bag
• Specification: 6.8*3.1*1.1
• Trademark: Scimagic-RC
• Origin: Mainland China
• HS Code: 85269200

Product Description

Product Description

Suits remote models: SEIP Garage Door Remote Control 433.92MHz Rolling Code

Comaptible Models

Remote Control Models:
SEIP SKR433
SEIP SKRJ433
SEIP SKR433-1
SEIP SKR433-3

Receiver Models:
RP60A,TM50,TM60,TM80,TS75,TS100,SE 1300 TS,EKR1MCG,EKR4MD,EKR4SP439


Access to receiver required. Please make sure you got access to your receiver/opener before purchase.

Disclaimer: Your remote control must be the same as the picture and your model must be in the list, we will not be responsible for wrong purchase

Description:

1.Type of programming: Programming with the receiver
2.Number of channels: 4
3. Code: rolling code
4. Frequency: 433.92MHz
5.Woring Range: 10-50 m (open space)
6.Remote come with Battery !!!

Programming

Note: after activating the learn mode with a MIDI hand-held transmitter (step 1), any other wireless commander can be programmed.
1.Place the MIDI remote control between the LED and the antenna connector directly on the housing and briefly press a hand
transmitter button.
2.The LED on the receiver now lights up permanently. This means that the reciever is now in learning-mode (for about one minute)
3.Briefly press the button of the radio device to be programmed. The LED on the receiver extinguishes, the radio device is now programmed and can be used.Repeat the programming procedure for each remote control / radio device.

Deleting the receivers memory:

1) Take any already programmed remote control
2) Hold the transmitter between the LED and the antenna connector directly on the receiver housing and press a hand transmitter key -the receiver LED will light up
3) Keep the hand transmitter button pressed until the LED goes out again (after approx. 8 seconds)The receiver memory is now completely deleted (ie all previously stored remote controls have been deleted!)

Include

* Remote Control
* Battery
* English Manual

Certifications