| Customization: | Available |
|---|---|
| Model Number: | Sommer Remote Control |
| Certification: | CE |
|
Still deciding? Get samples of $ !
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
SOMMER 434.42mhz Remote Control Replacement
Kindly note
Our remote is the COMPATIBLE / REPLACEMENT /CLONE remote , not the original one .
please make sure your remote / system can be used before buying .
if you are not so sure , please contact us without hesitate
Compatible model:
100% for SOMMER
4014 TX03-434-2
4013 TX02-434-4
4022 TX03-434-2
APERTO
4014 TX02-434-2
4013 TX03-434-4
4022 TX02-434-2
Programming transmitters to receiver
The remote control is the same function as your original remote.it should programming with original receiver according to your original Manual when you get it.
1. Locate the Learn / Code Set button on the motor. This is usually under the lamp cover, or on the back of the motor.
2. Press the Learn / Code Set button once, then let go. A light should illuminate.
3. Press the desired transmitter button once, and the light will go out.
4. Press the remote again the the light will flash on the motor and then go out, signifying the remote has been coded.
5. Test the operation of the remote.
Specifications
1.Type of programming: Programming with the receiver
2.Number of channels: 4
3. Code: rolling code
4. Frequency: 433.92MHz
5.Woring Range: 10-50 m (open space)
6.Remote come with Battery !!!
Programming
Note: after activating the learn mode with a MIDI hand-held transmitter (step 1), any other wireless commander can be programmed.
1.Place the MIDI remote control between the LED and the antenna connector directly on the housing and briefly press a hand
transmitter button.
2.The LED on the receiver now lights up permanently. This means that the reciever is now in learning-mode (for about one minute)
3.Briefly press the button of the radio device to be programmed. The LED on the receiver extinguishes, the radio device is now programmed and can be used.Repeat the programming procedure for each remote control / radio device.
Deleting the receivers memory:
1) Take any already programmed remote control
2) Hold the transmitter between the LED and the antenna connector directly on the receiver housing and press a hand transmitter key -the receiver LED will light up
3) Keep the hand transmitter button pressed until the LED goes out again (after approx. 8 seconds)The receiver memory is now completely deleted (ie all previously stored remote controls have been deleted!)
Shipped within 24 hours (except holidays)
Professional certificate, quality assurance
Our factory ShenZhen Scimagic Development Technology Co. Ltd is a high-tech company that specializes in designing, manufacturing and selling Alarm system ,wireless RF receiver (remote controller), RF Remote control ( key fob and transmitter), RF module (wireless transmitter Module and Receiver Module), Remote Control Duplicator( face to face copying duplicator and machine copy duplicator). We have been manufacturing electronic product for 10 years . Our professional R&D staff can meet your different request . We hope to promote mutual benefit and build long term business with customers all over the world by joint efforts.
){kind=link}